90mm VHB Adhesive Mounting Disk for Car Dashboards, GPS, Smartphones
Extra-strength adhesive mounting disc adheres to dashboards and works with any 80mm suction mounting pedestal
Compatible with Arkon CM017-KST-2SH, CM078WD-SBH, RM080AMPS, RM0792TWD, and RM0802T mounting pedestals
2 year limited warranty
The APVHB20 90mm adhesive mounting disk features an extra-strength 3M VHB adhesive and allows you to securely mount an Arkon or third-party 80mm windshield suction mounting pedestal to your car’s dashboard. Applicable Arkon mounting pedestal models include CM017-KST-2SH, CM078WD-SBH, RM080AMPS, RM0792TWD, and RM0802T. (Note that the disc is meant to be a bit larger than the mount to ensure a secure fit.) This package includes only the extra-strength adhesive disk (mounting pedestals sold separately). To apply the adhesive disk to the car’s dashboard, simply remove the paper backing from the back of the plastic 3M VHB dash mount disc, then place and press down on a previously cleaned surface. (Allow 24 hours for the adhesive to cure before securing the base of the mounting pedestal to the center of the disk for best results.) WARNING: Use caution and discretion when adhering APVHB20 to your car dashboard or other flat surface. This disk uses 3M VHB adhesive, which is designed to be a PERMANENT solution. Use of this disk may result in permanent adherence to the selected surface. Professional strength solvents or tools may be helpful in removing the adhesive. Arkon is not responsible for any damage caused to your vehicle or other surface due to the installation of this mounting disk. Adhesive disks with a semi-permanent bonding strength (Model AP036 – 70mm, Model AP013 – 80mm, Model AP020 – 90mm) are available from Arkon. For an extra-strength 80mm disk to use with 70mm suction mounts, see Arkon Model APVHB13.
This product may expose you to chemicals, which are known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov